To connect the diode, you must make sure
that its settings correspond to the electrical circuit. Also, before you
connect the diode should be checked for serviceability, the device is not out
of order. You will need Equipment needed: soldering iron, a screwdriver, a
wire, a knife, a multimeter and a line laser module.
Checking the diode as well. To do this, set
the multimeter to continuity test mode circuit or resistance measurement.
Conclusions diode and should not be connected to any equipment. Touch probes
conclusions diode and then change the location of the probe and repeat the
operation. Defective diode should call only in one direction. Remember or
somehow mark the conclusion to which the touch probe is positive polarity, when
the diode is ringing. This conclusion is called the anode.
Mounting diode and the AC circuit. Perform
a gap in the chain of alternating current, by cutting a wire or disconnect it
from the terminal of a power tool. Strip the ends of the wires using a
soldering iron. Solder terminals diode and to the resulting ends, or, if the
structure diode and, via wires connect bolting.
Installation of the red diode and the DC circuit. Follow the break in the circuit, and strip
the ends of the wires obtained. Determine the polarity of the voltage in the
circuit, which will be installed diode. This can be done by using a multimeter
in the DC measurement mode. Touch probes to the ends of the wires in the
generated circuit. If the reading on the display will be negative, the negative
or common probe located on the wire with positive polarity. If the reading is
positive, the positive probe touches the point with the appropriate polarity.
Determine polarities the diode and the electrical circuit. If the diode is used
as a conductive member, connect the anode to the point with a positive voltage.
When using a diode and an anode of the locking element joins the minus electric
circuit. Solder or otherwise attach the conclusions diode and to a portion of
the circuit.
没有评论:
发表评论